UAT Flash BIN ’00’ EMV Test Card Set (2xCards)
TECHNICAL NOTICE from Interac. We strongly advise you to read before ordering these cards: Issuer simulator setup for Flash Cards
- When using the contact interface in an Acquirer test environment, the Issuer simulator must be configured to return value ‘8840’ in ARPCrc response (ARPCrc byte 1 bits 6-3 should be set to zero).
- Unless Issuer simulator is configured to return ‘8840’, a contact transaction may block the card.
B2 will charge to replace cards blocked in this manner.
The Interac Flash test cards in this set are in the ‘001203’ BIN range.
These cards are supported by all Canadian processors but are not yet supported by all U.S. and International processors.
Check with your acquirer account representative to determine if this Interac Flash BIN range is supported by their development host.
If your processor does not yet support Interac Flash, the card will function properly at the POS device but it will not obtain a host approval.
This card set expires 12/2028.
Note: Card images below may not reflect current card definitions. Please refer to product documentation for details.
- Test Card 01 – Interac, 001203******0003, Dual Interface, English
- Test Card 02 – Interac, 001203******0003, Dual Interface, French